hot_standby

hot_standby — Allows connections and queries during recovery. Observed in PG9.0–19 Beta 3; its last measured boot default is on in PG19 Beta 3, with postmaster context. This is a beta-snapshot fact and can change before PostgreSQL 19 GA.

Note

Fact — official short description: “Allows connections and queries during recovery.”

Identity

Type , Valuebool: Upstream pg_settings type
Context , Valuepostmaster: Requires a server restart
Unit , Value—: Raw unit
Range , Value—: Raw limits in the last observed version
Enum values , Value—: — for non-enum types
Category , ValueReplication / Standby Servers: Upstream classification
Latest boot value , Valueon: on

Lifecycle

Fact	Value
First observed	PG9.0 (research boundary)
Present in	PG9.0–19 Beta 3
Removed in	No
Introduction commit	Not asserted: predates the PG9.0 research boundary
Commit date	—
Discussion	—

Default history

Measured PG9.0–19 Beta 3 boot defaults
Versions	Raw `boot_val`	Unit	Human value
PG9.0–9.6	`off`	—	off
PG10–19 Beta 3	`on`	—	on

How it works

Allows connections and queries during recovery. The value is fixed when the server starts, so changing it requires a restart.

When recovery has reached a consistent state, this permits read-only connections and queries. Replay still has priority: WAL records that conflict with snapshots or locks can cancel queries according to the standby-delay settings.

Monitor and change hot_standby together with primary_conninfo, primary_slot_name, restore_command. Validate on the relevant server role and real workload, then use its postmaster context to choose session change, reload, or restart; a historical boot default is not the current effective value.

Tuning advice

Tip

Advice. These are workload-specific starting points and must be validated with measurements.

Workload	Guidance
OLTP	Size hot_standby from topology, failover roles, slot/subscription count, and reconnect headroom. Test worst-case primary latency, standby replay, and disk retention before production.
OLAP	Read standbys and logical subscribers often see long queries or large transactions. Put explicit bounds on replay/apply and monitor lag, worker saturation, slot restart_lsn, and conflict cancellations.
Small nodes	Configure only replication capacity that is actually used. Even a small topology needs bounded timeouts and slot lifecycle; unlimited retention is not reliability.

Pigsty

Values use the fixed 8-vCPU, 32-GiB, 100-GiB SSD fixture and render the current Pigsty templates for PG19 Beta 3; this does not assert current Pigsty support for that historical or beta release.

Template	Effective value	Versus upstream boot	Source expression
OLTP	Unmodified	—	—
OLAP	Unmodified	—	—
CRIT	Unmodified	—	—
TINY	Unmodified	—	—

Caution

Advice — pending human review. Fact from the current Pigsty template projection: OLTP: PG9.0–19 Beta 3 unmodified; OLAP: PG9.0–19 Beta 3 unmodified; CRIT: PG9.0–19 Beta 3 unmodified; TINY: PG9.0–19 Beta 3 unmodified. No Pigsty-specific rationale is inferred from an absent override.

Common pitfalls

Changing it on the wrong primary, standby, sender, or subscriber role.
Watching only configured bytes/time instead of actual lag, slot position, and worker state.
Failing over to a node that lacks the old primary’s capacity or prerequisites.
Using infinite waits or WAL retention to hide a failed consumer.

primary_conninfo · primary_slot_name · restore_command · wal_receiver_timeout · wal_retrieve_retry_interval · max_standby_archive_delay